2014 Hilux · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Jun 2011


INSPECT LIGHTING TIME OF GLOW INDICATOR LIGHT

A112489E03

NOTICE:
Turn the ignition switch off for 60 seconds before performing this inspection.

  1. Turn the ignition switch to the ON position, and measure the lighting time.

    Lighting time:
    Refer to the graph


INSPECT PRE-HEATING

A112490E03

NOTICE:
Turn the ignition switch off for 60 seconds before performing this inspection.

  1. Turn the ignition switch to the ON position, and measure the time that the battery voltage is applied to the glow plugs.

    Standard pre-heating time :
    Engine Coolant Temperature Condition
    Specified Condition
    40°C (104°F) or more
    1 sec.
    40°C (104°F) or less
    Refer to the graph (15 sec. at the longest)

  1. Turn the ignition switch to the START position, and check that battery voltage is applied to the glow plugs.

  1. While cranking the engine, measure the time that the battery voltage is applied to the glow plugs.

    Standard pre-heating time:
    Engine Coolant Temperature Condition
    Specified Condition
    40°C (104°F) or more
    1 sec.
    40°C (104°F) or less
    Refer to the graph (15 sec. at the longest)


INSPECT AFTER GLOW TIME

NOTICE:
Turn the ignition switch off for 60 seconds before performing this inspection.


A122001E01
  1. After the engine starts, measure how long it takes for battery voltage to be applied to terminals E20-2 (SREL) and E23-14 (E1) of the ECM.

    Standard time:
    Tester Connection
    Specified Condition
    E20-2 (SREL) - E23-14 (E1)
    See graph

    If the result is not as specified, inspect the ECM, ECT sensor, glow plug and GLOW relay.

← SYSTEM DIAGRAM (from Jun 2011)COMPONENTS (from Jun 2011) →