2014 Hilux · Service Manual ENGINE

DISASSEMBLY

Removal / installation · Vehicles built from Jun 2011


1. REMOVE STARTER YOKE ASSEMBLY
  1. Remove the screw and terminal 50 wire.

  1. B000461E01
    Remove the nut and disconnect the terminal C wire.

  1. Remove the 2 screws and O-rings, and pull out the starter yoke assembly with the armature assembly.


2. REMOVE MAGNET STARTER SWITCH ASSEMBLY

  1. B000465E01
    Remove the 2 screws and magnet starter switch.

  1. Remove the return spring.

  1. B000464E01
    Remove the following parts from the starter housing.
    (1)
    Starter clutch
    (2)
    Starter armature pinion
    (3)
    Starter idler pinion
    (4)
    Retainer
    (5)
    Clutch roller

  1. P005056E01
    Using a magnetic finger, remove the steel ball.


3. REMOVE STARTER BRUSH HOLDER ASSEMBLY

  1. N000562E01
    Using a screwdriver, hold the spring back and disconnect the brush.

  1. Disconnect the 4 brushes and remove the brush holder.


4. REMOVE STARTER ARMATURE ASSEMBLY

  1. P005488E01
    Using a plastic-faced hammer, tap the end of the starter yoke and remove the armature.

← REMOVAL (from Jun 2011)INSPECTION (from Jun 2011) →