2014 Hilux · Service Manual ENGINE

REASSEMBLY

Removal / installation · Vehicles built from Jun 2011


1. INSTALL STARTER ARMATURE ASSEMBLY

  1. P004699E01
    Using a press, press in the armature.


2. INSTALL STARTER BRUSH HOLDER ASSEMBLY

  1. ST00096E01
    Align the claw of the brush holder with the claw groove of the starter yoke.

  1. Place the brush holder on the starter yoke.

  1. N000562E02
    Using a screwdriver, hold the brush spring back.

  1. Connect the brush onto the brush holder.

  1. Connect the 4 brushes.

    NOTICE:
    Check that the positive (+) lead wires are not grounded.

  1. Install a new O-ring to the groove of the starter yoke.


3. INSTALL MAGNET STARTER SWITCH ASSEMBLY
  1. Apply grease to the steel ball and return spring.

  1. Install the steel ball into the starter clutch sub-assembly hole.

  1. Insert the return spring into the magnet starter switch hole.

  1. B000464E03
    Place the following parts in position on the starter housing.
    (1)
    Starter clutch
    (2)
    Starter armature pinion
    (3)
    Starter idler pinion
    (4)
    Retainer
    (5)
    Clutch roller

  1. B000462E01
    Install the starter housing to the magnet switch assembly with the 2 screws.

    Torque:
    9.3 N*m{ 95 kgf*cm , 82 in.*lbf }


4. INSTALL STARTER YOKE ASSEMBLY
  1. Install a new O-ring to the groove of the starter yoke.

  1. Align the claws of the brush holder with the grooves of the magnet starter switch.

  1. Install the starter yoke with the armature.

  1. B000463E01
    Align the punch mark of the starter yoke with the line of the magnet starter switch.

  1. Install a new O-ring to the through bolt.

  1. B000461E02
    Install the 2 through bolts.

    Torque:
    12.7 N*m{ 130 kgf*cm , 9 ft.*lbf }

  1. Connect the terminal C wire with the nut.

    Torque:
    5.9 N*m{ 60 kgf*cm , 52 in.*lbf }

← INSPECTION (from Jun 2011)INSTALLATION (Jun 2011 – Jul 2012) →