2014 Hilux · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built from Aug 2013

Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013


1. INSTALL FUEL PRESSURE PULSATION DAMPER ASSEMBLY
  1. Apply a light coat of spindle oil or gasoline to a new O-ring and install it to the fuel pressure pulsation damper.

  1. Install the fuel pressure pulsation damper to the fuel delivery pipe.

  1. A078644E02
    Install the clip.


2. INSTALL INTAKE AIR SURGE TANK

A075648E01
  1. Install a new gasket and the surge tank with the 2 nuts.

    Torque:
    28 N*m{ 286 kgf*cm , 21 ft.*lbf }

  1. Using an 8 hexagon wrench, install the 4 bolts.

    Torque:
    28 N*m{ 286 kgf*cm , 21 ft.*lbf }

  1. A075647E01
    Install the 3 upper bolts which are used to secure the 2 surge tank stays and throttle body bracket.

    Torque:
    21 N*m{ 214 kgf*cm , 16 ft.*lbf }

  1. A075646E01
    Install the 3 wire harness clamps and hose clamp.

  1. Connect the throttle motor connector.

  1. Connect the 2 VSV connectors.

  1. A075645E01
    Connect the ventilation hose.

  1. A075644E01
    Connect the vapor feed hose assembly.

  1. A075598E01
    Connect the No. 4 water by-pass hose.

  1. A075597E01
    Connect the No. 5 water by-pass hose.


3. INSTALL AIR CLEANER ASSEMBLY

Torque:
8.0 N*m{ 82 kgf*cm , 71 in.*lbf }


4. CONNECT NO. 2 VENTILATION HOSE

A075594E01

5. INSTALL V-BANK COVER
  1. Install the cover with the 2 nuts.

    Torque:
    7.5 N*m{ 76.5 kgf*cm , 66 in.*lbf }


6. CONNECT CABLE TO BATTERY NEGATIVE TERMINAL

7. PERFORM INITIALIZATION
  1. Perform initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.


8. CHECK FOR FUEL LEAKS
  1. Connect the intelligent tester to the DLC3.

    1. Turn the ignition switch ON.

      NOTICE:
      Do not start the engine.

    2. Push the intelligent tester main switch ON.

    3. Select Active Test and enter the following menus: Powertrain / Engine and ECT / Active Test / Control the Fuel Pump / Speed.

  1. Check for fuel leaks.

    1. Check that there are no fuel leaks after performing maintenance anywhere on the fuel system.

← INSTALLATION (Aug 2012 – Jul 2013)COMPONENTS (from Jun 2011) →