Home › ENGINE › 1KD-FTV FUEL › FUEL SUPPLY PUMP (for DPF)
REMOVAL
Removal / installation · Vehicles built Jun 2011 – Jul 2012
Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013
NOTICE:
When replacing the injectors (including shuffling the injectors between the cylinders), common rail or cylinder head, it is necessary to replace the injection pipes with new ones.
When replacing the fuel supply pump, common rail, cylinder block, cylinder head, cylinder head gasket or timing gear case, it is necessary to replace the fuel inlet pipe with a new one.
After removing the fuel inlet pipe, clean it with a brush and compressed air.
1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here ).
2.
REMOVE RADIATOR ASSEMBLY
(Click here )
3.
REMOVE TIMING BELT
(Click here )
4.
REMOVE ELECTRIC EGR CONTROL VALVE ASSEMBLY WITH NO. 2 EGR VALVE AND EGR COOLER
(Click here )
5.
REMOVE NO. 4 INJECTION PIPE SUB-ASSEMBLY
Remove the bolt, nut and 2 No. 2 injection pipe clamps.
Using a 17 mm union nut wrench, loosen the union nuts and remove the No. 4 injection pipe.
6.
REMOVE WIRING HARNESS CLAMP BRACKET
Detach the wire harness clamp.
Text in Illustration
*A
for LHD
*B
for RHD
*1
Wiring Harness Clamp Bracket
Remove the bolt and wiring harness clamp bracket.
7.
REMOVE NO. 2 FUEL PIPE
Disconnect the vacuum switching valve connector and 2 vacuum transmitting hoses.
Using a 6 mm hexagon wrench, remove the supply pump hollow screw and gasket.
Text in Illustration
Bolt
Supply Pump Hollow Screw
Fuel Check Valve
Union Bolt
Remove the fuel check valve, union bolt and 2 gaskets.
Remove the 3 bolts and No. 2 fuel pipe.
8.
REMOVE FUEL SUPPLY PUMP ASSEMBLY
Disconnect the 2 fuel hoses.
Disconnect the fuel temperature sensor connector and suction control valve connector from the fuel supply pump.
Remove the 4 bolts indicated by the arrows in the illustration.
Remove the No. 2 camshaft timing pulley flange and pump drive shaft pulley.
Remove the set nut and O-ring while holding the crankshaft pulley using SST.
SST
09213-58014 09330-00021
Loosen the 2 nuts.
Using SST, disconnect the fuel supply pump from the injection gear.
SST
09950-50013
(09951-05010, 09952-05010, 09953-05020, 09954-05021)
NOTICE:
Apply lubricant to the threads and tip of SST (center bolt) before using it.
Remove the 2 nuts and fuel supply pump.
NOTICE:
Do not hold or carry the fuel supply pump by the pipe.
The fuel supply pump must be kept horizontal.
Remove the O-ring.