2014 Hilux · Service Manual ENGINE

REPLACEMENT

Removal / installation · Vehicles built Jun 2011 – Jul 2012

Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013

HINT:
When replacing the filter, use TOYOTA genuine parts or equivalent parts.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


2. LOOSEN FUEL TANK CAP ASSEMBLY

3. REMOVE FUEL FILTER ELEMENT

A098900E01

HINT:
Replacement of the fuel filter element can be performed with the fuel filter installed to the bracket.

  1. Disconnect the warning switch connector.

  1. Move the clip to disconnect the hose connected to the filter inlet side.

  1. Connect a hose to the drain cock. Place the other side of the same hose into a container.

  1. Loosen the drain cock to drain fuel (approximately 50 cc (3.0 cu in.)).

  1. Tighten the drain cock.

  1. A098901E01
    Using a screwdriver as a lever, loosen the fastener nut until it can be loosened by hand.

  1. A098907E01
    Fully loosen the fastener nut by hand.

  1. A098902E01
    To remove the cap, pull up one side of the cap and then lift it off.

  1. Remove the filter element from the case.

  1. Remove the case side O-ring.


4. INSTALL FUEL FILTER ELEMENT

A098903E01
  1. Attach 2 new O-rings to a new element and a new O-ring to the case.

  1. Install the element to the case.

  1. A098904E01
    Align the cap's mark and case's mark.

  1. A099012E01
    Push the cap into the case by hand.

    Clearance (A):
    1.5 mm (0.059 in.) or less

    HINT:
    The clearance between the cap and case should be even around the entire circumference of the cap and case.

  1. G038643E01
    Turn the fastener nut until a "click" sound is heard.

    HINT:
    Just before the marks of the case and nut align, the turning difficulty of the fastener nut will increase. Use a screwdriver as a lever to turn the fastener nut.

  1. Measure the distance between the marks on the cap and case, and the clearance between the cap and case.

    Distance (A):
    1 mm (0.039 in.) or more

    Clearance (B):
    1 mm (0.039 in.) or less

  1. A115162
    Connect the hose to the filter inlet side and install the clip as shown in the illustration.


5. TIGHTEN FUEL TANK CAP ASSEMBLY

6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

7. PERFORM INITIALIZATION
  1. Perform initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.


8. RESET FUEL SYSTEM WARNING LIGHT

G034749E01
  1. Turn the ignition switch ON.

  1. After turning the ignition switch ON, connect the warning switch connector within 3 to 60 seconds.

  1. Check that the combination meter's fuel system warning lamp turns off.


9. BLEED AIR FROM FUEL SYSTEM

A098962E01
  1. Using the hand pump, bleed air from the fuel system until pumping becomes difficult.


10. CHECK FOR FUEL LEAKS
  1. Start the engine. Check that leaking sounds, sucking sounds or other unusual sounds cannot be heard.

← INSPECTION (from Jun 2011)REPLACEMENT (Aug 2012 – Jul 2013) →