2014 Hilux · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Jun 2011


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


2. REMOVE V-BANK COVER
  1. Remove the 2 nuts and cover.


3. REMOVE INTAKE AIR SURGE TANK

  1. A075597E01
    Disconnect the No. 5 water by-pass hose.

  1. A075598E01
    Disconnect the No. 4 water by-pass hose.

  1. A075644E01
    Disconnect the fuel vapor feed hose assembly.

  1. A075645E01
    Disconnect the ventilation hose.

  1. A075646E01
    Disconnect the 2 VSV connectors.

  1. Disconnect the throttle motor connector.

  1. Remove the 3 wire harness clamps and hose clamp.

  1. A075647E01
    Remove the 3 upper bolts, which are used to secure the 2 surge tank stays and throttle body bracket.

  1. A075648E01
    Using an 8 mm hexagon wrench, remove the 4 bolts.

  1. Remove the 2 nuts, intake air surge tank and gasket.


4. REMOVE VENTILATION VALVE SUB-ASSEMBLY

A112001
  1. Loosen the hose clamp and disconnect the ventilation hose from the valve.

  1. Remove the valve.

← COMPONENTS (from Jun 2011)INSPECTION (from Jun 2011) →