2014 Hilux · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built from Jun 2011


INSPECT OIL PUMP RELIEF VALVE

P012091E01
  1. Coat the relief valve with engine oil and drop it into the relief vale hole.

  1. Check that the relief valve falls in smoothly by its own weight.
    If it does not, replace the relief valve. If necessary, replace the timing gear case.


INSPECT OIL PUMP ASSEMBLY

A059946E01
  1. Install the driven rotor into the timing gear case with the mark facing the cylinder block side.

  1. A051289E01
    Check the tip clearance.

    1. Using a feeler gauge, measure the clearance between the drive and driven rotor tips.

      Tip clearance:
      Specification
      Clearance
      Standard
      0.060 to 0.160 mm (0.0024 to 0.0063 in.)
      Maximum
      0.21 mm (0.0083 in.)

      If the tip clearance is greater than the maximum, replace the driven rotor and gear case with new ones.

  1. A051290E01
    Check the body clearance.

    1. Using a feeler gauge, measure the clearance between the oil pump body and drive rotor.

      Body clearance:
      Specification
      Clearance
      Standard
      0.100 to 0.170 mm (0.0039 to 0.0066 in.)
      Maximum
      0.20 mm (0.0078 in.)

      If the body clearance is greater than the maximum, replace the driven rotor and gear case with new ones.

  1. A051291E01
    Check the side clearance.

    1. Using a feeler gauge and precision straightedge, measure the clearance between the rotor and precision straightedge.

      Side clearance:
      Specification
      Clearance
      Standard
      0.030 to 0.090 mm (0.0012 to 0.0036 in.)
      Maximum
      0.15 mm (0.0059 in.)

      If the side clearance is greater than the maximum, replace the driven rotor and gear case with new ones.

← DISASSEMBLY (from Jun 2011)REPLACEMENT (from Jun 2011) →