INSTALLATION
Removal / installation · Vehicles built from Aug 2013
Versions by build date: Jun 2011 – Jul 2013 from Aug 2013
| 1.
INSTALL HEADLIGHT DIMMER SWITCH ASSEMBLY |
 |
- Install the headlight dimmer switch with the claw as shown in the illustration.
- Install the headlight dimmer switch with the clamp.
- Connect the connector.
| 2.
INSTALL WIPER AND WASHER SWITCH ASSEMBLY
|
 |
- Attach the claw to install the windshield washer switch.
- NOTICE:
- Do not push the claw with excessive force as damage may occur.
Connect the connectors.
| 3.
INSTALL SPIRAL CABLE SUB-ASSEMBLY
|
 |
Check that the front wheels are facing straight ahead.
Set the turn signal switch to the neutral position.
- NOTICE:
- Make sure that the turn signal switch is in the neutral position, as the pin of the turn signal switch may be snapped.
Install the spiral cable.
- NOTICE:
- When replacing the spiral cable with a new one, remove the lock pin before installing the steering wheel.
Connect the connectors to the spiral cable.
- NOTICE:
- When handling the airbag connector, do not damage the airbag wire harness.
| 4.
INSTALL STEERING COLUMN COVER UPPER
|
 |
Install the cover lower with the 3 screws.
| 5.
INSTALL STEERING COLUMN COVER LOWER
|
 |
Install the cover lower with the 3 screws.
| 6.
INSTALL STEERING WHEEL ASSEMBLY
|
 |
- for 3 spoke:
Apply the silicon grease to the steering wheel.
Align the matchmarks on the steering wheel and main shaft.
Install the steering set nut.
-
Torque:
- 50 N*m{
510 kgf*cm
, 37 ft.*lbf
}
| 7.
PLACE FRONT WHEELS FACING STRAIGHT AHEAD |
|
| 8.
INSPECT STEERING WHEEL CENTER POINT |
|
| 9.
INSTALL STEERING PAD ASSEMBLY
|
 |
- Support the steering pad with one hand.
Connect the connector to the steering pad.
- NOTICE:
- When handling the airbag connector, take care not to damage the airbag wire harness.
Connect the horn connector.
Confirm that the groove along the circumference of the "TORX" screw is attached to the screw case and place the steering pad onto the steering wheel.
Using a T30 "TORX" socket wrench, tighten the 2 screws.
-
Torque:
- 8.8 N*m{
90 kgf*cm
, 78 in.*lbf
}
| 10.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
|
| 11.
INSPECT STEERING PAD ASSEMBLY
|
 |
- Support the steering pad with one hand.
Connect the connector to the steering pad.
- NOTICE:
- When handling the airbag connector, take care not to damage the airbag wire harness.
Connect the horn connector.
Confirm that the groove along the circumference of the "TORX" screw is attached to the screw case and place the steering pad onto the steering wheel.
Using a T30 "TORX" socket wrench, tighten the 2 screws.
-
Torque:
- 8.8 N*m{
90 kgf*cm
, 78 in.*lbf
}
| 12.
PERFORM INITIALIZATION |
 |
Perform initialization (Click here).
- NOTICE:
- Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
| 13.
CHECK SRS WARNING LIGHT |
 |
Check the SRS warning light (Click here).