2014 Hilux · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Jun 2011


CHECK INTEGRATION RELAY

  1. G038997E01
    A112973
    Using a screwdriver, detach the 2 claws and disconnect the integration relay from the engine room junction block.

    HINT:
    Tape the screwdriver tip before use.


    1. Measure the voltage of the C/OPN relay.

      Standard resistance:
      Tester Connection
      Condition
      Specified Condition
      IJ-8 - Body ground
      Ignition switch ON
      10 to 14 V

      If the result is not as specified, replace the integration relay.

    2. A112973
      Measure the voltage of the MAIN relay.

      Standard resistance:
      Tester Connection
      Condition
      Specified Condition
      IJ-4 - Body ground
      Ignition switch ON
      10 to 14 V

      If the result is not as specified, replace the integration relay.

← COMPONENTS (from Jun 2011)INSPECTION (from Jun 2011) →