ON-VEHICLE INSPECTION
Inspection · Vehicles built from Jun 2011
| INSPECT INTEGRATION NO.1 RELAY |
 |
- Using a screwdriver, detach the 2 claws and disconnect the integration relay from the engine room junction block.
- HINT:
- Tape the screwdriver tip before use.
- Measure the voltage of the MAIN relay.
- Standard resistance:
Tester Connection
|
Condition
|
Specified Condition
|
IJ-4 - Body ground
|
Ignition switch ON
|
10 to 14 V
|
If the result is not as specified, replace the integration relay.