2014 Hilux · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Jun 2011


INSPECT INTEGRATION NO.1 RELAY

  1. G038997
    Using a screwdriver, detach the 2 claws and disconnect the integration relay from the engine room junction block.

    HINT:
    Tape the screwdriver tip before use.


    1. G039047E12
      Measure the voltage of the EDU relay.

      Standard resistance:
      Tester Connection
      Condition
      Specified Condition
      1J-8 - Body ground
      Ignition switch ON
      10 to 14 V

      If the result is not as specified, replace the integration relay.

    2. G039047E12
      Measure the voltage of the MAIN relay.

      Standard resistance:
      Tester Connection
      Condition
      Specified Condition
      1J-4 - Body ground
      Ignition switch ON
      10 to 14 V

      If the result is not as specified, replace the integration relay.

← INSTALLATION (from Aug 2013)ON-VEHICLE INSPECTION (from Jun 2011) →