2014 Hilux · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Jun 2011


REMOVE GLOW RELAY (Marking: GLOW)
  1. Remove the engine room relay block cover.

  1. Remove the glow relay from the engine room relay block.


INSPECT GLOW RELAY

  1. A111813E02
    Measure the resistance of the glow relay.

    Standard resistance:
    Tester Connection
    Specified Condition
    3 - 5
    10 kΩ or higher
    3 - 5
    Below 1 Ω
    (when battery voltage is applied to terminals 1 and 2)

    If the result is not as specified, replace the relay.

  1. Reinstall the glow relay to the engine room relay block.

  1. Reinstall the engine room relay block cover.


INSTALL GLOW RELAY
← ON-VEHICLE INSPECTION (from Jun 2011)COMPONENTS (from Jun 2011) →