ON-VEHICLE INSPECTION
Inspection · Vehicles built from Aug 2013
Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013
| DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
 |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
| REMOVE GLOW RELAY (Marking: GLOW) |
 |
Remove the engine room relay block cover.
Remove the glow relay from the engine room relay block.
| INSPECT GLOW RELAY |
 |
- Measure the resistance of the glow relay.
- Standard resistance:
Tester Connection
|
Specified Condition
|
3 - 5
|
10 kΩ or higher
|
3 - 5
|
Below 1 Ω (when battery voltage is applied to terminals 1 and 2)
|
If the result is not as specified, replace the relay.
| CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
|
| PERFORM INITIALIZATION |
 |
Perform initialization (Click here).
- NOTICE:
- Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.