REMOVAL
Removal / installation · Vehicles built from Jun 2011
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
| 2. REMOVE ENGINE COVER SUB-ASSEMBLY |
![]() ![]() |
Remove the 3 bolts, 2 nuts and cover.
| 3. REMOVE INTAKE AIR TEMPERATURE SENSOR |
Disconnect the IAT sensor connector.
Using a 22 mm deep socket wrench, remove the IAT sensor.

- HINT:
- Replace the IAT sensor if it is deformed, cracked or malfunctioning. It is not necessary to replace the IAT sensor each time the CAC is replaced.

