REMOVAL
Removal / installation · Vehicles built from Jun 2011
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE ENGINE COVER SUB-ASSEMBLY |
Remove the 3 bolts, 2 nuts and cover.

| 3. REMOVE INTAKE AIR TEMPERATURE SENSOR |
Disconnect the IAT sensor connector.

Using a 22 mm deep socket wrench, remove the IAT sensor.
- HINT:
- Replace the IAT sensor if it is deformed, cracked or malfunctioning. It is not necessary to replace the IAT sensor each time the intercooler is replaced.
