2014 Hilux · Service Manual ENGINE

REPAIR

Removal / installation · Vehicles built from Jun 2011


1. REPAIR INTAKE VALVE SEAT

A059921E01
  1. Check the valve seating position.

    1. Apply a light coat of prussian blue (or white lead) to the valve face.

    2. Lightly press the valve against the seat. Do not rotate valve.

  1. Check the valve face and seat for the following:

    1. If blue appears 360° around the face, the valve is concentric. If not, replace the valve.

    2. If blue appears 360° around the valve seat, the guide and face are concentric. If not, resurface the seat.

    3. Check that the seat contact is in the middle of the valve face with the width below.

      Standard width:
      1.2 to 1.6 mm (0.047 to 0.063 in.)

  1. A053831E06
    If the seating is too high on the valve face, use 25 and 45° cutters to correct the seat.

  1. A053832E06
    If the seating is too low on the valve face, use 70 and 45° cutters to correct the seat.

  1. A059928E01
    Handrub the valve and valve seat with an abrasive compound.

  1. After handrubbing, clean the valve and valve seat.


2. REPAIR EXHAUST VALVE SEAT

A059920E01
  1. Check the valve seating position.

    1. Apply a light coat of prussian blue (or white lead) to the valve face.

    2. Lightly press the valve against the seat. Do not rotate valve.

  1. Check the valve face and seat for the following:

    1. If blue appears 360° around the face, the valve is concentric. If not, replace the valve.

    2. If blue appears 360° around the valve seat, the guide and face are concentric. If not, resurface the seat.

    3. Check that the seat contact is in the middle of the valve face with the width below.

      Standard width:
      1.6 to 2.0 mm (0.063 to 0.079 in.)

  1. A053831E07
    If the seating is too high on the valve face, use 25 and 45° cutters to correct the seat.

  1. A053832E07
    If the seating is too low on the valve face, use 75 and 45° cutters to correct the seat.

  1. A058111E01
    Handrub the valve and valve seat with an abrasive compound.

  1. After handrubbing, clean the valve and valve seat.

← INSTALLATION (from Aug 2013)COMPONENTS (from Jun 2011) →