INSTALLATION
Removal / installation · Vehicles built from Jun 2011
| 1. INSTALL FAN |
Install the fan to the coupling with the 4 nuts.

- Torque:
- 6.0 N*m{ 61 kgf*cm , 53 in.*lbf }
| 2. INSTALL FAN SHROUD |
Install the fan pulley to the water pump.
Install the shroud together with the coupling fan between the radiator and engine component.
- NOTICE:
- Be careful not to damage the radiator core.
Install the fluid coupling fan to the fan pulley with the 4 nuts.
Tighten the nuts as much as possible by hand.
Attach the shroud's claws to the radiator.

Install the shroud with the 2 bolts.
- Torque:
- 5.0 N*m{ 51 kgf*cm , 44 in.*lbf }
Install the drive belt (Click here).
Tighten the 4 nuts of the fluid coupling fan.
- Torque:
- 18 N*m{ 184 kgf*cm , 13 ft.*lbf }
Install the radiator reservoir with the 2 bolts.

- Torque:
- 5.0 N*m{ 51 kgf*cm , 44 in.*lbf }
Connect the No. 1 and No. 2 water by-pass hoses to the tank upper and lower.
Install the oil reservoir with the 3 bolts.

- Torque:
- 4.5 N*m{ 46 kgf*cm , 40 in.*lbf }
| 3. CONNECT RADIATOR HOSE INLET |
| 4. ADD ENGINE COOLANT |
Add the engine coolant (Click here).
| 5. CHECK FOR ENGINE COOLANT LEAKS |
Check for the engine coolant leaks (Click here).
| 6. INSTALL NO. 1 ENGINE UNDER COVER |
Install the cover with the 4 bolts.
- Torque:
- 28 N*m{ 286 kgf*cm , 21 ft.*lbf }
