2014 Hilux · Service Manual ENGINE

REPAIR

Removal / installation · Vehicles built from Jun 2011


1. REPAIR VALVE SEAT

NOTICE:
Take off a cutter gradually to makes smooth valve seat.

  1. P012729E01
    Apply a light coat of Prussian blue (or white lead) to the valve face.

  1. Lightly press the valve against the valve seat.

    NOTICE:
    Do not rotate the valve.

  1. Check the valve face and seat according to the following procedure.

    1. If blue appears 360° around the face, the valve is concentric.
      If not, replace the valve.

    2. If blue appears 360° around the valve seat, the guide and face are concentric.
      If not, resurface the valve seat.

    3. Check that the seat contact is in the middle of the valve face with these width.

      Standard width:
      1.0 to 1.4 mm (0.039 to 0.055 in.)

  1. A062787E03
    If the seating is too high on the valve face, use 30° and 45°cutters to correct the seat.

  1. A075613E02
    Intake side:
    If the seating is too low on the valve face, use 60°and 45°cutters to correct the seat.

  1. A062788E02
    Exhaust side:
    If the seating is too low on the valve face, use 75°and 45°cutters to correct the seat.

  1. A075614E01
    Hand-lap the valve and valve seat with an abrasive compound.

  1. After hand-lapping, clean the valve and valve seat.

← REASSEMBLY (from Aug 2014)ON-VEHICLE INSPECTION (Jun 2011 – Jul 2012) →