INSTALLATION
Removal / installation · Vehicles built Jun 2011 – Jul 2012
Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013
| 1.
INSTALL HEATED OXYGEN SENSOR (2WD) |
 |
- Using SST, install the sensor.
- SST
- 09224-00010
-
Torque:
- 44 N*m{
449 kgf*cm
, 32 ft.*lbf
}
for use without SST
- 40 N*m{
408 kgf*cm
, 30 ft.*lbf
}
for use with SST
- HINT:
- Use a torque wrench with a fulcrum length of 30 cm (11.81 in.).
- Connect the sensor connector.
| 2.
INSTALL HEATED OXYGEN SENSOR (4WD) |
 |
- Using SST, install the sensor.
- SST
- 09224-00010
-
Torque:
- 44 N*m{
449 kgf*cm
, 32 ft.*lbf
}
for use without SST
- 40 N*m{
408 kgf*cm
, 30 ft.*lbf
}
for use with SST
- HINT:
- Use a torque wrench with a fulcrum length of 30 cm (11.81 in.).
- Attach the 3 wire clamps to the vehicle body.
Connect the sensor connector.
| 3.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
|
| 4.
PERFORM INITIALIZATION |
 |
Perform initialization (Click here).
- NOTICE:
- Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.