REMOVAL
Removal / installation · Vehicles built from Jun 2011
- CAUTION:
- Wear protective gloves when removing the heated oxygen sensor.
- The exhaust pipe assembly is extremely hot immediately after the engine has stopped.
- Confirm that the exhaust pipe assembly has cooled down before removing it.
| 1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
 |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
| 2.
REMOVE HEATED OXYGEN SENSOR (2WD) |
 |
- Disconnect the sensor connector.
- Using SST, remove the sensor.
- SST
- 09224-00010
| 3.
REMOVE HEATED OXYGEN SENSOR (4WD) |
 |
- Disconnect the sensor connector.
Disconnect the sensor wire from the clamp.
- Using SST, remove the sensor.
- SST
- 09224-00010