INSTALLATION
Removal / installation · Vehicles built from Jun 2011
| 1. INSTALL INTERCOOLER ASSEMBLY |
Install a new gasket and the intake air connector with the 4 bolts.
- Torque:
- 10 N*m{ 102 kgf*cm , 7 ft.*lbf }
Install the intercooler with the 4 bolts.
- Torque:
- 12 N*m{ 122 kgf*cm , 9 ft.*lbf }
Install a new No. 2 air hose and then tighten the 2 hose clamps.
- Torque:
- 6.5 N*m{ 66 kgf*cm , 58 in.*lbf }
Tighten the 2 hose clamps of the No. 1 air hose.
- Torque:
- 6.5 N*m{ 66 kgf*cm , 58 in.*lbf }
| 2. INSTALL INTAKE AIR TEMPERATURE SENSOR |
Using a 22 mm deep socket wrench, install a new gasket and the intake air temperature sensor.
- Torque:
- 29 N*m{ 300 kgf*cm , 22 ft.*lbf }
Connect the intake air temperature sensor connector and glow plug connector.
Attach the clamp.
| 3. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY |
Install the engine cover with the 3 bolts and 2 cap nuts.
- Torque:
- 7.0 N*m{ 71 kgf*cm , 62 in.*lbf }
