REMOVAL
Removal / installation · Vehicles built from Aug 2013
Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013
- HINT:
- Use the same procedure for RHD and LHD vehicles.
- The procedure listed below is for LHD vehicles.
| 1.
REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY
|
 |
Slightly bend the upper part of the glove compartment door to release the 2 stoppers and open the glove compartment door until it is horizontal.
Text in Illustration
*1
|
Stopper
|
- Pull the glove compartment door toward the rear of the vehicle to detach the 2 hinges and remove the glove compartment door.
Text in Illustration
*1
|
Hinge
|
| 2.
REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY
|
 |
Detach the 2 claws, 3 clips and 3 guides and remove the lower instrument panel finish panel.
| 3.
REMOVE SWITCH BASE
|
 |
Detach the 8 claws.
- HINT:
- If the claws are difficult to detach, detach the claws from the back of the switch base.
Disconnect the connectors and remove the switch base..
| 4.
REMOVE HEATER SWITCH ASSEMBLY |
 |
Disconnect the connector.
Detach the 2 claws and remove the heater switch assembly.