2014 Hilux · Service Manual STEERING

REASSEMBLY

Removal / installation · Vehicles built from Jun 2011


1. INSTALL STEERING MAIN SHAFT ASSEMBLY

  1. G034354E01
    Using a snap ring expander, install a new steering main shaft snap ring (inner side) to the steering main shaft.

  1. Install the steering main shaft to the steering column tube.

  1. G034355E01
    Using a snap ring expander, install a steering main shaft snap ring.


2. INSTALL STEERING MAIN SHAFT BEARING

  1. C241393E01
    Using SST and a hammer, tap in the bearing until it is flush with the edge of the steering column tube.
    SST
    09608-06041  


3. INSTALL KEY INTER LOCK SOLENOID (for Automatic Transmission)

  1. G034357E01
    Install the solenoid to the steering column bracket upper with the 2 screws.


4. INSTALL IGNITION OR STARTER SWITCH ASSEMBLY

  1. A099992E01
    Install the switch to the steering column bracket upper with the 2 claws.


5. INSTALL UNLOCK WARNING SWITCH ASSEMBLY

  1. G034352E01
    Install the switch to the steering column bracket upper with the 2 claws.


6. INSTALL IGNITION SWITCH LOCK CYLINDER ASSEMBLY
  1. Make sure that the lock cylinder is on ACC.

  1. Install the ignition switch lock cylinder.


7. INSTALL STEERING LOCK OPERATION
  1. Check that the steering lock mechanism activated when the key is removed.

  1. Check that the steering lock mechanism is deactivated when the key is inserted and turned to the ACC position.
    If there is any abnormality, replace the ignition switch lock cylinder assembly.


8. INSTALL STEERING COLUMN UPPER WITH SWITCH BRACKET ASSEMBLY

  1. G034356E01
    Install the steering column upper bracket and steering column upper clamp with 2 new tapered-head bolts.

  1. Tighten the 2 tapered-head bolts until the bolt heads break off.


9. INSTALL TRANSPONDER KEY AMPLIFIER (w/ Engine Immobiliser System)
  1. Connect the transponder key amplifier connector.

  1. G034429E03
    Align the claw of the transponder key amplifier with the upper bracket.

  1. Push in the transponder key amplifier and install it to the upper bracket.

    NOTICE:
    Do not push in the amplifier with excessive force as it may be damaged.


10. INSTALL KEY CYLINDER LIGHT ASSEMBLY (w/ Key Cylinder Light)

  1. E226243
    Connect the connector.

  1. Push in the key cylinder light assembly in the direction indicated by the arrow in the illustration to install it.


11. INSTALL NO. 2 STEERING INTERMEDIATE SHAFT SUB-ASSEMBLY

  1. G036669E05
    Align the matchmarks on the steering intermediate shaft and steering gear.

  1. Install the steering intermediate shaft to the steering gear with the bolt.

    Torque:
    35 N*m{ 357 kgf*cm , 26 ft.*lbf }


12. INSTALL STEERING SLIDING WITH COUPLING YOKE SUB-ASSEMBLY

  1. G034345E04
    Align the matchmarks on the yoke and steering main shaft.

  1. Install the steering yoke with the bolt.

    Torque:
    28 N*m{ 286 kgf*cm , 21 ft.*lbf }

← DISASSEMBLY (from Jun 2011)INSTALLATION (Jun 2011 – Jul 2012) →