DATA LIST / ACTIVE TEST
System information · Vehicles built Jun 2011 – Jul 2013
Versions by build date: Jun 2011 – Jul 2013 from Aug 2013
| DATA LIST |
- HINT:
- Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
- NOTICE:
- In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Warm up the engine.
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Engine and ECT: Powertrain / Engine and ECT / Data List / All Data.
According to the display on the intelligent tester, read the Data List.
Engine and ECT Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Engine Speed
Engine speed/Min.: 0 rpm, Max.: 16383 rpm
550 to 780 rpm (When idling)
When the crankshaft position sensor is malfunctioning, "Engine Speed" is approximately 0 or varies greatly from the actual engine speed.
Vehicle Speed
Min.: 0 km/h, Max.: 255 km/h
Speed indicated on speedometer
-
| ACTIVE TEST |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Chassis / ABS/VSC/TRC / Active Test.
According to the display on the intelligent tester, perform the Active Test.
ABS/VSC/TRC Tester Display
Test Part
Control Range
Diagnostic Note
ABS Warning Light*1
ABS warning light
OFF/ON
Confirm that the vehicle is stopped with the ignition switch ON.
VSC Warning Light*2
VSC OFF indicator light
OFF/ON
Confirm that the vehicle is stopped with the ignition switch ON.
Brake Warning Light*2
Brake warning light
OFF/ON
Confirm that the vehicle is stopped with the ignition switch ON.
Slip Indicator Light*2
SLIP indicator light
OFF/ON
Confirm that the vehicle is stopped with the ignition switch ON.
- *1: w/ ABS
- *2: w/ VSC
- *1: w/ ABS