INSPECTION
Inspection · Vehicles built from Jun 2011
| INSPECT OVERDRIVE ONE-WAY CLUTCH |
![]() ![]() |
Hold the overdrive direct clutch drum, and turn the input shaft.
Check that the input shaft can be turned freely clockwise and locks when turned counterclockwise.
| INSPECT OVERDRIVE DIRECT CLUTCH DRUM |
![]() ![]() |
Using a dial indicator, measure the inside diameter of the clutch drum bushes.
- Maximum inside diameter:
- 27.11 mm (1.0673 in.)
| INSPECT PISTON STROKE OF OVERDRIVE DIRECT CLUTCH |
![]() ![]() |
Place the oil pump onto the torque converter clutch, and then place the overdrive direct clutch drum assembly onto the oil pump.
Using SST and a dial indicator, measure the overdrive direct clutch piston stroke while applying and releasing compressed air (392 kPa (4.0 kgf/cm2, 57 psi)).

- SST
- 09350-30020
(09350-06120)
- Standard piston stroke:
- 1.85 to 2.15 mm (0.0728 to 0.0846 in.)
| INSPECT OVERDRIVE DIRECT CLUTCH DISC |
![]() ![]() |
Replace all discs if one of the following problems is present: 1) a disc, plate or flange is worn or burnt, 2) the lining of a disc is peeled off or discolored, or 3) grooves or printed numbers have even a little bit of damage.
- HINT:
- Before assembling new discs, soak them in ATF for at least 15 minutes.
| INSPECT OVERDRIVE DIRECT CLUTCH RETURN SPRING |
![]() ![]() |
Using a vernier caliper, measure the free length of the spring together with the spring seat.
- Standard free length:
- 15.8 mm (0.622 in.)
| INSPECT OVERDRIVE DIRECT CLUTCH PISTON |
![]() ![]() |
Check that the check ball is free by shaking the piston.
Check that the valve does not have leaks by applying low-pressure compressed air.
| INSPECT OVERDRIVE PLANETARY GEAR |
![]() ![]() |
Using a dial indicator, measure the inside diameter of the planetary gear bush.
- Maximum inside diameter:
- 11.27 mm (0.4437 in.)
Using a feeler gauge, measure the planetary pinion gear thrust clearance.

- Standard clearance:
- 0.20 to 0.60 mm (0.0079 to 0.0236 in.)
- Maximum clearance:
- 0.65 mm (0.0256 in.)







