Removal / installation · Vehicles built from Jun 2011
1.
INSPECT ONE-WAY CLUTCH ASSEMBLY
Hold the planetary sun gear, and turn the one-way clutch assembly. Check that the one-way clutch hub can be turned freely clockwise and locks when turned counterclockwise.
2.
REMOVE ONE-WAY CLUTCH ASSEMBLY
3.
REMOVE NO. 1 ONE-WAY CLUTCH THRUST WASHER
4.
REMOVE SUN GEAR SHAFT OIL SEAL RING
Remove the 2 oil seal rings from the sun gear input drum.
5.
REMOVE SUN GEAR INPUT DRUM
Use a wooden block or similar object as a work stand.
Using snap ring pliers, remove the snap ring.
Remove the input drum from the planetary sun gear.
6.
REMOVE SUN GEAR INPUT DRUM SHAFT SNAP RING
Using a screwdriver, pry out the snap ring from the planetary sun gear.
7.
INSPECT PLANETARY SUN GEAR
Using a dial indicator, measure the inside diameter of the planetary sun gear bushes.
Maximum inside diameter:
27.08 mm (1.0661 in.)
If the inside diameter is greater than the maximum, replace the planetary sun gear.