2014 Hilux · Service Manual TRANSMISSION

DISASSEMBLY

Removal / installation · Vehicles built from Jun 2011


1. INSPECT ONE-WAY CLUTCH ASSEMBLY

AT08440E01
  1. Hold the planetary sun gear, and turn the one-way clutch assembly. Check that the one-way clutch hub can be turned freely clockwise and locks when turned counterclockwise.


2. REMOVE ONE-WAY CLUTCH ASSEMBLY

AT08188E01

3. REMOVE NO. 1 ONE-WAY CLUTCH THRUST WASHER

AT01642E01

4. REMOVE SUN GEAR SHAFT OIL SEAL RING

AT08189E01
  1. Remove the 2 oil seal rings from the sun gear input drum.


5. REMOVE SUN GEAR INPUT DRUM

AT08190E01
  1. Use a wooden block or similar object as a work stand.

  1. Using snap ring pliers, remove the snap ring.

  1. Remove the input drum from the planetary sun gear.


6. REMOVE SUN GEAR INPUT DRUM SHAFT SNAP RING

AT08182E01
  1. Using a screwdriver, pry out the snap ring from the planetary sun gear.


7. INSPECT PLANETARY SUN GEAR

AT08337E01
  1. Using a dial indicator, measure the inside diameter of the planetary sun gear bushes.

    Maximum inside diameter:
    27.08 mm (1.0661 in.)

    If the inside diameter is greater than the maximum, replace the planetary sun gear.

← COMPONENTS (from Jun 2011)INSPECTION (from Jun 2011) →