2014 Hilux · Service Manual HEATER & AIR CONDITIONING SYSTEM

REASSEMBLY

Removal / installation · Vehicles built from Jun 2011


1. INSTALL MAGNET CLUTCH ASSEMBLY

E171833
  1. Install the magnet clutch stator with the parts aligned as shown in the illustration.

  1. E155204
    Using a snap ring expander, install a new snap ring with the chamfered side facing outward.

    NOTICE:
    When installing the snap ring, do not widen it excessively.

  1. E155205
    Using a snap ring expander, install the magnet clutch rotor and a new snap ring with the chamfered side facing outward.

    NOTICE:
    Do not damage the seal cover of the bearing when installing the snap ring.
    When installing the snap ring, do not widen it excessively.

  1. Install the magnet clutch washer(s) and magnet clutch hub.

    NOTICE:
    Do not change the combination of magnet clutch washer(s) used before disassembly.

  1. E213727E02
    Install the bolt.

    Torque:
    13 N*m{ 135 kgf*cm , 10 ft.*lbf }

    NOTICE:
    1. Make sure that there is no foreign matter or oil on the compressor shaft, bolt and clutch hub.
    2. When reusing the drive belt, check the belt for wear, cracks or other signs of damage.

    Text in Illustration 
    *1
    Battery


2. INSTALL COOLER BRACKET
  1. Connect the ground wire and install the cooler bracket with the screw.

  1. Attach the clamp.


3. INSPECT MAGNET CLUTCH CLEARANCE

E213814E03
  1. Clamp the cooler compressor in a vise between aluminum plates.

  1. Set a dial indicator to the magnet clutch hub.

  1. Connect the battery positive (+) lead to terminal 1 of the magnet clutch connector. Turn the magnet clutch on and off by connecting and disconnecting the battery negative (-) lead to and from the ground wire, and measure the clearance.

    Standard clearance:
    0.25 to 0.50 mm (0.010 to 0.020 in.)

    If the measured value is not within the standard clearance, remove the magnet clutch hub and adjust the clearance using magnet clutch washers to obtain the standard clearance.

    Magnet clutch washer thickness:
    0.1 mm (0.004 in.)
    0.3 mm (0.012 in.)
    0.5 mm (0.020 in.)

    NOTICE:
    Adjustment should be performed with 3 or less magnet clutch washers.

    Text in Illustration 
    *1
    Magnet Clutch Hub
    *2
    Dial Indicator
    *3
    Battery
    *a
    Component without harness connected
    (Magnet Clutch Assembly)

  1. Remove the cooler compressor from the vise.

← INSPECTION (from Jun 2011)INSTALLATION (from Jun 2011) →