2014 Hilux · Service Manual TRANSMISSION

L4 Position Switch Circuit

Circuit diagnosis · Vehicles built from Jun 2011

DESCRIPTION

The No. 1 transfer indicator switch (L4 position switch) detects the gear position of the transfer shift lever.
Moving the transfer shift lever to L4 turns the L4 position switch ON. Then the ECM cancels operation of the lock-up clutch.

WIRING DIAGRAM

C175018E04

INSPECTION PROCEDURE


1. CHECK WIRE HARNESS (NO. 1 TRANSFER INDICATOR SWITCH - BODY GROUND)

  1. C155110E04
    Disconnect the T4 switch connector.

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    T4-2 - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


2. INSPECT NO. 1 TRANSFER INDICATOR SWITCH (L4 POSITION SWITCH)
A110992E11
  1. Remove the transfer indicator switch.

  1. Measure the resistance of the switch when pushing the ball at the tip of the switch.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 2
    Not pushed
    10 kΩ or higher
    1 - 2
    Pushed
    Below 1 Ω



NG
REPLACE NO. 1 TRANSFER INDICATOR SWITCH
OK


3. CHECK WIRE HARNESS (NO. 1 TRANSFER INDICATOR SWITCH - ECM)
C175020E02
  1. Disconnect the T4 switch connector.

  1. Disconnect the E9 ECM connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E9-11 (L4) - T4-1
    Always
    Below 1 Ω
    E9-11 (L4) or T4-1 - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE ECM


← Stop Light Switch Circuit (from Jun 2011)A/T P Indicator Circuit (from Jun 2011) →