TCM Power Source Circuit
Circuit diagnosis · Vehicles built from Jun 2011
DESCRIPTION
When the ignition switch is turned ON, battery voltage is applied to terminal IG2 of the TCM.WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK TCM (IG2 VOLTAGE) |
![]() ![]() |
Turn the ignition switch ON.
Measure the voltage of the TCM connectors.
- Standard voltage:
Tester Connection
Specified Condition
T38-6 (IG2) - T19-1 (E1)
9 to 14 V
|
|
||||
| NG | |
| 2. CHECK WIRE HARNESS (TCM - BODY GROUND) |
Disconnect the T19 TCM connector.

Measure the resistance of the wire harness side connector.
- Standard resistance:
Tester Connection
Specified Condition
T19-1 (E1)- Body ground
Below 1 Ω
|
|
||||
| OK | |
| 3. INSPECT FUSE (IGN) |
![]() ![]() |
Remove the IGN fuse from the instrument panel junction block.
Measure the resistance of the fuse.
- Standard resistance:
- Below 1 Ω
|
|
||||
| OK | |
| 4. INSPECT IGNITION SWITCH |
Disconnect the I6 ignition switch connector.

Measure the resistance of the ignition switch.
- Standard resistance:
Tester Connection
Switch Condition
Specified Condition
5 (AM2) - 6 (IG2)
LOCK
10 kΩ or higher
5 (AM2) - 6 (IG2)
ON
Below 1 Ω
|
|
||||
| OK | ||
| ||


