2014 Hilux · Service Manual TRANSMISSION

TCM Power Source Circuit

Circuit diagnosis · Vehicles built from Jun 2011

DESCRIPTION

When the ignition switch is turned ON, battery voltage is applied to terminal IG2 of the TCM.

WIRING DIAGRAM

C122129E01

INSPECTION PROCEDURE


1. CHECK TCM (IG2 VOLTAGE)
G039243E09
  1. Turn the ignition switch ON.

  1. Measure the voltage of the TCM connectors.

    Standard voltage:
    Tester Connection
    Specified Condition
    T38-6 (IG2) - T19-1 (E1)
    9 to 14 V



OK
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
NG


2. CHECK WIRE HARNESS (TCM - BODY GROUND)

  1. F045523E08
    Disconnect the T19 TCM connector.

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Specified Condition
    T19-1 (E1)- Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


3. INSPECT FUSE (IGN)
A111770E01
  1. Remove the IGN fuse from the instrument panel junction block.

  1. Measure the resistance of the fuse.

    Standard resistance:
    Below 1 Ω



NG
REPLACE FUSE
OK


4. INSPECT IGNITION SWITCH

  1. A056879E04
    Disconnect the I6 ignition switch connector.

  1. Measure the resistance of the ignition switch.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    5 (AM2) - 6 (IG2)
    LOCK
    10 kΩ or higher
    5 (AM2) - 6 (IG2)
    ON
    Below 1 Ω



NG
REPLACE IGNITION SWITCH
OK

REPAIR OR REPLACE HARNESS AND CONNECTOR (BATTERY - IGNITION SWITCH, IGNITION SWITCH - TCM)


← U0100/A2 Lost Communication with ECM/PCM "A" (from Jun 2011)Park / Neutral Position Switch Circuit (Jun 2011 – Jul 2012) →