2014 Hilux · Service Manual ENGINE

REASSEMBLY

Removal / installation · Vehicles built from Jun 2011


1. INSTALL OIL PUMP DRIVE GEAR

  1. A057452E01
    Place the timing belt case on wooden blocks.

    NOTICE:
    Do not damage the timing pointer.

  1. A057459E01
    Insert the drive and driven gears into the timing belt case with the marks facing the oil pump cover side.

  1. A057460E01
    Apply adhesive to 2 or 3 threads of the screws.

    Adhesive:
    Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

  1. Install the oil pump cover with the 8 screws.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }


2. INSTALL OIL PUMP RELIEF VALVE
  1. Insert the relief valve and spring into the installation hole of the timing belt case.

  1. A057453E02
    Using a 12 mm hexagon wrench, install a new gasket and the plug.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }

← REPLACEMENT (from Jun 2011)INSTALLATION (from Jun 2011) →