2014 Hilux · Service Manual ENGINE

REASSEMBLY

Removal / installation · Vehicles built from Aug 2013

Versions by build date: Jun 2011 – Jul 2013 from Aug 2013


1. INSTALL GENERATOR ROTOR ASSEMBLY

  1. A122149
    Place the drive end frame on the pulley.

  1. Install the rotor to the drive end frame.


2. INSTALL GENERATOR COIL ASSEMBLY

  1. A122150
    Place the generator washer on the rotor.

  1. A122151E01
    Using SST and a press, slowly press on the coil assembly.
    SST
    09285-76010  

  1. A196079
    Install the 4 bolts.

    Torque:
    5.8 N*m{ 59 kgf*cm , 51 in.*lbf }


3. INSTALL GENERATOR BRUSH HOLDER ASSEMBLY

  1. A079315E06
    While pushing the 2 brushes inside the brush holder, insert a pin (diameter: 1.0 mm (0.039 in.)) into the brush holder hole.

  1. A196080E01
    Install the generator brush holder with the 2 screws.

    Torque:
    1.8 N*m{ 18 kgf*cm , 16 in.*lbf }

  1. Pull out the pin from the generator brush holder.


4. INSTALL GENERATOR REAR END COVER

  1. A196077
    Install the terminal insulator to the generator coil.

    NOTICE:
    Pay attention to the mounting orientation of the terminal insulator.

  1. A122140
    Install the end cover with the 3 nuts.

    Torque:
    4.6 N*m{ 47 kgf*cm , 41 in.*lbf }


5. INSTALL GENERATOR PULLEY WITH CLUTCH
  1. Mount the generator in a vise between aluminum plates.

  1. Temporarily install the generator pulley by hand.

  1. A203706E01
    Install SST (A) and (B) to the generator pulley as shown in the illustration.
    SST
    09820-63021  

  1. A203708E01
    Using a wrench to hold SST (A), turn SST (B) clockwise to tighten the generator pulley.

    Torque:
    without SST:
    111 N*m{ 1127 kgf*cm , 81 ft.*lbf }
    with SST:
    80 N*m{ 814 kgf*cm , 58 ft.*lbf }

    HINT:
    1. Use a torque wrench with a fulcrum length of 260 mm (10.2 in.). When using a torque wrench with a fulcrum length that is not 260 mm (10.2 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification (Click here).
    2. Make sure SST and the wrench are connected in a straight line.

  1. Check that the generator pulley rotates smoothly.


6. INSTALL GENERATOR PULLEY CAP

  1. A194780E01
    Install a new generator pulley cap.

    NOTICE:
    1. Align the cap guide of the generator pulley cap with the hole of the generator pulley and push it in by hand.
    2. Do not push in the generator pulley cap at an angle.

← REASSEMBLY (Jun 2011 – Jul 2013)INSTALLATION (Jun 2011 – Jul 2012) →