2014 Hilux · Service Manual ENGINE

DISASSEMBLY

Removal / installation · Vehicles built from Jun 2011


1. REMOVE STARTER YOKE ASSEMBLY

  1. P013020
    Remove the nut and disconnect the lead wire from terminal C.

  1. A074859
    Remove the 2 bolts and 2 O-rings.

  1. Pull out the starter yoke with the armature.

  1. Remove the O-ring from the starter yoke.


2. REMOVE MAGNET STARTER SWITCH ASSEMBLY

  1. A102596
    Remove the 2 screws and magnet starter switch assembly.

  1. Remove the return spring.

  1. Remove the pinion gear, idler gear, clutch roller, retainer and starter clutch assembly from the starter drive housing.

    A121405E03

  1. A115020E02
    Using a magnet hand, remove the steel ball from the clutch shaft hole.

  1. A204323E01
    for seal type:
    Remove the O-ring from the starter drive end housing.


3. REMOVE STARTER BRUSH HOLDER ASSEMBLY

  1. N000562
    Disconnect the 4 starter yoke brushes from the brush holder.

    1. Using a screwdriver, pull back the spring.

    2. Disconnect the brush from the brush holder.

  1. Remove the brush holder from the starter yoke.


4. REMOVE STARTER ARMATURE ASSEMBLY

  1. P005488
    Using a plastic-faced hammer, tap the end of the starter yoke to remove the starter armature from the starter yoke.

← REMOVAL (from Aug 2013)INSPECTION (from Jun 2011) →