2014 Hilux · Service Manual ENGINE

REASSEMBLY

Removal / installation · Vehicles built from Jun 2011


1. INSTALL STARTER CLUTCH SUB-ASSEMBLY

  1. A202613E01
    Apply high-temperature grease to the starter clutch sub-assembly, idler gear, steel ball, return spring, clutch roller and retainer.

  1. Insert the steel ball into the starter clutch hole.

  1. Insert the return spring into the starter clutch hole.

  1. Install the starter clutch sub-assembly, idler gear, retainer and clutch roller to the starter drive housing.

  1. A199400
    Install the starter drive housing to the magnet starter switch with the 2 screws.

    Torque:
    5.9 N*m{ 60 kgf*cm , 52 in.*lbf }


2. INSTALL STARTER ARMATURE ASSEMBLY

  1. A202109
    Apply high-temperature grease to the armature bearing.

  1. Install the starter armature to the starter yoke.


3. INSTALL STARTER BRUSH HOLDER ASSEMBLY
  1. Install a new O-ring to the groove of the starter yoke.

  1. Install the starter brush holder to the starter yoke.

  1. Install the 4 starter brushes to the starter brush holder.

    1. A050090
      Using a screwdriver, pull back the spring.

    2. Install the brush to the brush holder.

      NOTICE:
      Make sure that the positive (+) lead wires are not grounded.

  1. A173938
    Install the commutator end frame with the 2 screws.

    Torque:
    1.5 N*m{ 15 kgf*cm , 13 in.*lbf }


4. INSTALL STARTER YOKE ASSEMBLY
  1. Install a new O-ring to the groove of the starter yoke.

  1. A170755E01
    Align the protrusion of the starter yoke with the groove of the magnet starter switch.

  1. A199399
    Install the starter yoke with the 2 through bolts.

    Torque:
    5.9 N*m{ 60 kgf*cm , 52 in.*lbf }

  1. Connect the lead wire to terminal C with the nut.

    Torque:
    5.9 N*m{ 60 kgf*cm , 52 in.*lbf }

← INSPECTION (from Jun 2011)INSTALLATION (Jun 2011 – Jul 2012) →