2014 Hilux · Service Manual ENGINE

REASSEMBLY

Removal / installation · Vehicles built from Jun 2011


1. INSTALL MAGNET STARTER SWITCH ASSEMBLY

  1. A204324E01
    for seal type:
    Install a new O-ring to the groove of the starter drive end housing.

  1. Apply high-temperature grease to the idler gear, pinion gear, steel ball, return spring, clutch roller and retainer.

  1. P005018
    Install the steel ball.

  1. Insert the return spring into the starter clutch hole.

  1. Install the starter clutch, pinion gear, idler gear, retainer and clutch roller to the starter drive housing.

    A121405E03

  1. S004230
    Install the starter drive housing to the magnet starter switch assembly with the 2 screws.

    Torque:
    9.3 N*m{ 95 kgf*cm , 82 in.*lbf }


2. INSTALL STARTER ARMATURE ASSEMBLY
  1. Apply high-temperature grease to the starter armature bearing.

  1. P004699
    Using a press, press the starter armature into the starter yoke assembly to install it.


3. INSTALL STARTER BRUSH HOLDER ASSEMBLY

  1. ST00096E03
    Align the claw of the brush holder with the claw groove of the starter yoke assembly.

  1. Install the brush holder to the starter yoke assembly.

  1. N000562
    Install the 4 starter yoke brushes to the brush holder.

    1. Using a screwdriver, pull back the spring.

    2. Install the brush to the brush holder.

      NOTICE:
      Check that the positive (+) lead wires are not grounded.


4. INSTALL STARTER YOKE ASSEMBLY

  1. ST00100
    Install a new O-ring to the groove of the starter yoke assembly.

  1. A195057
    Align the punch mark of the starter yoke assembly with the line of the magnet starter switch assembly and install the starter yoke assembly.

  1. S004229E01
    Install 2 new O-rings to the bolts.

  1. Install the 2 bolts.

    Torque:
    12.7 N*m{ 130 kgf*cm , 9 ft.*lbf }

  1. P013020
    Connect the lead wire to terminal C with the nut.

    Torque:
    5.9 N*m{ 60 kgf*cm , 52 in.*lbf }

← INSPECTION (from Jun 2011)INSTALLATION (Jun 2011 – Jul 2012) →