P0717 Input Speed Sensor Circuit No Signal
Diagnostic trouble codes · Vehicles built Jun 2011 – Jul 2013
Versions by build date: Jun 2011 – Jul 2013 from Aug 2013
DESCRIPTION


The O/D direct clutch speed sensor (NC0) detects the rotation speed of the O/D input shaft from the rotation speed of the O/D direct clutch drum. Its construction is the same as that of the No. 2 vehicle speed sensor (SP2).
By comparing the O/D direct clutch speed sensor (NC0) signal with the No. 2 vehicle speed sensor (SP2) signal, the TCM detects the shift timing of the gears and controls the engine torque and hydraulic pressure according to various conditions. As a result, smooth gear shift is achieved.
| DTC No. |
DTC Detection Condition |
Trouble Area |
| P0717 |
|
|
- *1: w/ OBD
- *2: w/o OBD
MONITOR DESCRIPTION
The input speed sensor (NC0) detects the transmission input shaft speed. The TCM determines the gear shift timing based on a comparison of the input speed sensor (NC0) (input shaft speed) with the output speed sensor (output shaft speed).When the output shaft speed is higher than the expected value and the input shaft speed is 300 rpm or less while the vehicle is running with the shift lever on D, the TCM will conclude that there is a malfunction in the input speed sensor (NC0). The TCM will illuminate the MIL and set the DTC.
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK SPEED SENSOR (INSTALLATION) |
Check the speed sensor installation.

- OK:
- Installation bolt is tightened properly and there is no clearance between sensor and transmission case.
|
|
||||
| OK | |
| 2. INSPECT O/D DIRECT CLUTCH SPEED SENSOR |
![]() ![]() |
Disconnect the T6 sensor connector from the transmission.
Measure the resistance of the sensor.
- Standard resistance:
Tester Connection
Condition
Specified Condition
1 - 2
20°C (68°F)
560 to 680 Ω
- HINT:
-


- Reference: Inspect using an oscilloscope.
- Check the waveform of the TCM connector.
- OK:
- Refer to illustration
Item
Content
Tester Connection
T19-3 (NC0+) - T19-2 (NC0-)
Tool Setting
5 V/DIV, 0.5 msec./DIV.
Condition
Engine is idling
|
|
||||
| OK | |
| 3. CHECK WIRE HARNESS (O/D DIRECT CLUTCH SPEED SENSOR - ECM) |
Disconnect the T19 TCM connector.

Measure the resistance of the wire harness side connector.
- Standard resistance:
Tester Connection
Condition
Specified Condition
T19-3 (NC0+) - T19-2 (NC0-)
20°C (68°F)
560 to 680 Ω
T19-3 (NC0+) - Body ground
20°C (68°F)
10 kΩ or higher
T19-2 (NC0-) - Body ground
20°C (68°F)
10 kΩ or higher
|
|
||||
| OK | ||
| ||

