2014 Hilux · Service Manual TRANSMISSION

P0717 Turbine Speed Sensor Circuit No Signal

Diagnostic trouble codes · Vehicles built from Jun 2011

DESCRIPTION

This sensor detects the rotation speed of the turbine which shows the input revolution of the transmission. By comparing the input turbine speed signal NT with the counter gear speed sensor signal SP2, the TCM detects the shift timing of the gears and appropriately controls the engine torque and hydraulic pressure according to various conditions. As a result, the gears shift smoothly.
DTC Code
DTC Detection Condition
Trouble Area
P0717
All the conditions below are detected for 5 sec. or more (1 trip detection logic).
(a) Gear change is not performed.
(b) The gear position is 4th or 5th.
(c) The T/M input shaft rpm is 300 rpm or less.
(d) The T/M output shaft rpm is 1000 rpm or more.
(e) The park/neutral position switch:
  1. The NSW input signal is OFF.
  2. The R input signal is OFF.
(f) The shift solenoid valves and park/neutral position switch are operating normally.
  1. Open or short in speed sensor (NT) circuit
  2. Speed sensor (NT)
  3. TCM

MONITOR DESCRIPTION

This DTC indicates that a pulse is not output from the speed sensor NT (turbine (input) speed sensor) or is output only a little. The NT terminal of the TCM detects the pulse signal from the speed sensor NT (input RPM). The TCM outputs a gear shift signal comparing the input speed sensor NT with the output speed sensor SP2.
While the vehicle is operating in the 4th or 5th gear position with the shift lever in D, if the input shaft revolution is less than 300 rpm*1 although the output shaft revolution is 1000 rpm or more*2, the TCM detects the trouble, illuminates the MIL and stores the DTC.

HINT:
  1. *1: Pulse is not output or is irregularly output.
  2. *2: The vehicle speed is approximately 50 km/h (31 mph) or more.


WIRING DIAGRAM

C155187E43

INSPECTION PROCEDURE


1. CHECK SPEED SENSOR (INSTALLATION)

  1. C159067E02
    Check the speed sensor NT installation.

    OK:
    The installation bolt is tightened properly and there is no clearance between the sensor and transmission case.



NG
SECURELY INSTALL SPEED SENSOR OR REPLACE SPEED SENSOR
OK


2. INSPECT SPEED SENSOR (NT)
C159420E20
  1. Disconnect the T6 speed sensor connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    20°C (68°F)
    560 to 680 Ω



NG
REPLACE SPEED SENSOR (NT)
OK


3. CHECK HARNESS AND CONNECTOR (SPEED SENSOR (NT) - TCM)

  1. C191544E22
    Disconnect the T19 TCM connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    T19-3 (NT+) - T19-2 (NT-)
    20°C (68°F)
    560 to 680 Ω
    T19-3 (NT+) - Body ground
    Always
    10 kΩ or higher
    T19-2 (NT-) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE TCM


← P0711 Transmission Fluid Temperature Sensor "A" Performance (from Jun 2011)P0722 Output Speed Sensor Circuit No Signal (from Jun 2011) →