P0405 Exhaust Gas Recirculation Sensor "A" Circuit Low
Diagnostic trouble codes · Vehicles built from Aug 2014
Also covers:
- P0406 Exhaust Gas Recirculation Sensor "A" Circuit High
Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
The EGR valve position sensor is mounted on the EGR valve and used for detecting the lift amount of the valve. The lift amount detected by the sensor is provided to the ECM as feedback, and then the ECM regulates the lift amount of the valve in accordance with the engine running condition.| DTC No. |
DTC Detection Condition |
Trouble Area |
| P0405 |
EGR valve position sensor output voltage is less than 0.1 V for more than 5 seconds (1 trip detection logic) |
|
| P0406 |
EGR valve position sensor output voltage is more than 4.9 V for more than 5 seconds (1 trip detection logic) |
|
- HINT:
- After confirming DTCs P0405 and P0406, check the EGR valve opening angle condition.
Result
Condition
Changes between 0.3 to 4.2 V
Normal
Less than 0.1 V
P0405 (Low input voltage)
More than 4.9 V
P0406 (High input voltage)
- The result values above are for when the ignition switch is ON (engine is stopped), or when the engine is fully warmed-up and idling.
- After confirming DTCs P0405 and P0406, check the EGR valve opening angle condition.
MONITOR DESCRIPTION


When the output voltage of the EGR valve position sensor deviates from the normal operating range of 0.1 to 4.9 V for more than 0.5 seconds, the ECM interprets this as a malfunction of the sensor circuit, and illuminates the MIL.
WIRING DIAGRAM


INSPECTION PROCEDURE
- HINT:
- Read freeze frame data using the intelligent tester. Freeze frame data records the engine conditions when a malfunction is detected. When troubleshooting, freeze frame data can help determine if the vehicle was running or stopped, if the engine was warmed up or not, and other data from the time the malfunction occurred.
- NOTICE:
- If the ECM is replaced, the new ECM needs initialization (Click here).
| 1. CHECK ECM (VC VOLTAGE) |
![]() ![]() |
Disconnect the E2 EGR valve position sensor connector.
Measure the voltage of the wire harness side connector.
- Standard voltage:
Tester Connection
Specified Condition
E2-1 (VC) - E2-2 (E2)
4.5 to 5.5 V
|
|
||||
| OK | |
| 2. INSPECT EGR VALVE POSITION SENSOR (RESISTANCE) |
|
|
||||
| OK | |
| 3. CHECK WIRE HARNESS (EGR VALVE POSITION SENSOR - ECM) |
![]() ![]() |
Disconnect the E2 sensor connector.
Disconnect the E7 and E8 ECM connectors.
Measure the resistance of the wire harness side connectors.
- Standard resistance:
Tester Connection
Specified Condition
E2-3 (EGLS) - E7-33 (EGLS)
Below 1 Ω
E2-2 (E2) - E8-28 (E2)
Below 1 Ω
E2-3 (EGLS) or E7-33 (EGLS) - Body ground
10 kΩ or higher
E2-2 (E2) or E8-28 (E2) - Body ground
10 kΩ or higher
|
|
||||
| OK | ||
| ||


