2014 Hilux · Service Manual ENGINE

DISASSEMBLY

Removal / installation · Vehicles built from Jun 2011


1. REMOVE REPAIR SERVICE STARTER KIT

  1. A081590
    Remove the nut, and then disconnect the lead wire from terminal C.

  1. A082688
    Remove the 2 screws holding the repair service starter kit to the starter drive housing.

  1. Remove the repair service starter kit.

  1. Remove the return spring and plunger from the starter drive housing.


2. REMOVE STARTER YOKE ASSEMBLY

  1. A082689
    Remove the 2 through bolts and pull out the starter yoke assembly together with the starter commutator end frame.

  1. A083800
    Remove the starter commutator end frame from the starter yoke.


3. REMOVE STARTER ARMATURE PLATE

  1. A083803
    Remove the starter armature plate from the starter yoke.


4. REMOVE STARTER COMMUTATOR END FRAME COVER

  1. A083801
    Using a screwdriver, remove the starter commutator end frame cover.


5. REMOVE STARTER ARMATURE ASSEMBLY

NOTICE:
Do not drop the starter armature assembly.

  1. Hold the starter commutator end frame between aluminum plates in a vise.

    NOTICE:
    Do not damage the starter commutator end frame.

  1. A073993
    Using snap ring pliers, remove the snap ring and plate washer.

    NOTICE:
    Do not drop the starter armature assembly.

  1. Remove the starter armature from the commutator end frame.


6. REMOVE PLANET GEAR

  1. A082690
    Remove the 3 planetary gears from the starter center bearing clutch.


7. REMOVE STARTER CENTER BEARING CLUTCH SUB-ASSEMBLY

A073990
  1. Remove the starter center bearing clutch and starter drive lever set pin from the starter drive housing.

  1. Remove the starter drive lever set pin from the starter center bearing clutch.

← REMOVAL (from Aug 2013)INSPECTION (from Jun 2011) →