2014 Hilux · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Jun 2011


CHECK DIFFERENTIAL PRESSURE SENSOR ASSEMBLY
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the intelligent tester on.

  1. Enter the following menus: Powertrain / Engine / Data List / DPNR Differential Pressure.

  1. Disconnect the No. 6 exhaust pipe air hose from the sensor.

  1. A244978E01
    Using SST, apply pressure to the differential pressure sensor.
    SST
    09992-00242  
    Text in Illustration 
    *a
    Pressure
    *b
    Front Side of Vehicle

  1. Check the pressure value of the sensor.

    Standard pressure:
    Approximately the same pressure as the applied pressure indicated on the tester.

    HINT:
    Perform the inspection by applying a pressure within the range of 0 to 98 kPa (0 to 1.0 kgf/cm2, 0 to 14.2 psi).

    If the result is not as specified, check the sensor circuit (Click here).

  1. Connect the No. 6 exhaust pipe air hose to the differential pressure sensor.

← COMPONENTS (from Jun 2011)REMOVAL (from Jun 2011) →