DISASSEMBLY
Removal / installation · Vehicles built Jun 2011 – Jul 2013
Versions by build date: Jun 2011 – Jul 2013 from Aug 2013
| 1.
REMOVE REPAIR SERVICE STARTER KIT |
 |
- Remove the nut and disconnect the lead wire from the terminal C.
- Remove the 2 screws holding the repair service starter kit to the starter drive housing.
Remove the repair service starter kit.
Remove the return spring and plunger from the starter drive housing.
| 2.
REMOVE STARTER YOKE ASSEMBLY |
 |
- Remove the 2 bolts, and pull out the starter yoke assembly together with the starter commutator end frame.
| 3.
REMOVE STARTER COMMUTATOR END FRAME ASSEMBLY |
 |
- Remove the starter commutator end frame from the starter yoke.
| 4.
REMOVE STARTER ARMATURE PLATE |
 |
- Remove the starter armature plate from the starter yoke.
| 5.
REMOVE STARTER COMMUTATOR END FRAME COVER |
 |
- Using a screwdriver, remove the starter commutator end frame cover.
| 6.
REMOVE STARTER ARMATURE ASSEMBLY |
 |
- NOTICE:
- Do not drop the starter armature assembly.
Hold the starter commutator end frame between aluminum plates in a vise.
- NOTICE:
- Do not damage the starter commutator end frame.
- Using snap ring pliers, remove the snap ring and plate washer.
Remove the starter armature from the commutator end frame.
| 7.
REMOVE PLANETARY GEAR |
 |
- Remove the 3 planetary gears from the starter drive housing.
| 8.
REMOVE STARTER CENTER BEARING CLUTCH SUB-ASSEMBLY |
 |
- Remove the starter center bearing clutch and starter drive lever set pin from the starter drive housing.
Remove the starter drive lever set pin from the starter center bearing clutch.