DISASSEMBLY
Removal / installation · Vehicles built from Jun 2011
| 1.
REMOVE GENERATOR PULLEY |
 |
- Install SST 1-A and B to the generator rotor shaft.
- SST
- 09820-63011
(09820-06010, 09820-06021)
Item
|
Part No.
|
SST 1-A and B
|
09820-06010
|
SST 2
|
09820-06021
|
Hold SST 1-A with a torque wrench, and tighten SST 1-B clockwise with the specified torque.
-
Torque:
- 39 N*m{
398 kgf*cm
, 29 ft.*lbf
}
- NOTICE:
- Make sure that the SST is secured to the generator rotor shaft.
Mount the generator in a vise between aluminum plates.
- Insert SST 2 to attach it to the pulley nut.
- To loosen the pulley nut, turn SST 1-A in the direction shown in the illustration.
- NOTICE:
- To prevent damage to the rotor shaft, do not loosen the pulley nut more than one-half turn.
Remove SST 2 from the generator.
- Turn SST 1-B in the direction shown in the illustration, and remove SST 1-A and B.
Remove the pulley nut and pulley.
| 2.
REMOVE GENERATOR REAR END COVER |
 |
- Remove the 3 nuts and generator rear end cover.
| 3.
REMOVE TERMINAL INSULATOR |
 |
- Remove the terminal insulator.
| 4.
REMOVE GENERATOR BRUSH HOLDER ASSEMBLY |
 |
- Remove the 2 screws and brush holder.
| 5.
REMOVE GENERATOR COIL ASSEMBLY |
 |
- Remove the 4 bolts.
- Using SST, remove the generator coil assembly.
- SST
- 09950-40011
(09951-04020, 09952-04010, 09953-04020, 09954-04010, 09955-04071, 09957-04010, 09958-04011)
| 6.
REMOVE GENERATOR ROTOR ASSEMBLY |
 |
Remove the washer from the generator rotor.
Remove the drive end frame space collar.
Remove the rotor from the drive end frame.
| 7.
INSPECT GENERATOR DRIVE END FRAME BEARING |
 |
- Check that the bearing is not rough or worn, and that it rotates smoothly.
If necessary, replace the drive end frame bearing.
| 8.
REMOVE GENERATOR DRIVE END FRAME BEARING |
 |
- Remove the 4 screws and bearing retainer.
- Using SST and a hammer, tap out the bearing.
- SST
- 09950-60010
(09951-00250)
09950-70010
(09951-07100)