2014 Hilux · Service Manual ENGINE

Charging Failure

Circuit diagnosis · Vehicles built from Aug 2013

INSPECTION PROCEDURE


1. CHECK LOCK FUNCTION OF GENERATOR CLUTCH PULLEY
  1. Start the engine and visually check if the fan of the generator rotor assembly located inside the generator assembly is operating.

    OK:
    The fan of the generator rotor assembly is operating.

    Result:
    Result
    Proceed to
    OK
    A
    NG (for DENSO Made)
    B
    NG (for BOSCH Made)
    C



B
REPLACE GENERATOR PULLEY WITH CLUTCH (Click here)

C
REPLACE GENERATOR PULLEY WITH CLUTCH (Click here)
A


2. CHECK GENERATOR PULLEY WITH CLUTCH (UNIT INSPECTION)
  1. Remove the generator assembly.

    1. for DENSO Made: (Click here)
    2. for BOSCH Made: (Click here)

  1. Check the installation condition of the generator pulley cap.

    OK:
    The generator pulley cap is not loose or missing.

  1. Check for grease leaks (for wet pulley) or particle formation due to friction (for dry pulley).

    OK:
    No grease leaks (for wet pulley) or large build-up of particles (for dry pulley).

  1. Check the generator pulley with clutch for misalignment (interference with the generator assembly).

    OK:
    The generator pulley with clutch is correctly aligned (no interference with the generator assembly).

  1. A288972
    Turn the generator pulley with clutch clockwise and counterclockwise by hand and check for noise.

    OK:
    Noise does not occur when turned in both directions.

  1. Turn the generator pulley with clutch clockwise and counterclockwise by hand and visually check for runout.

    OK:
    The generator pulley with clutch does not have runout.

  1. A288971
    Using a screwdriver, hold the fan of the generator rotor assembly located inside the generator assembly in place and check that the generator pulley with clutch locks when turned clockwise and turns freely when turned counterclockwise.

    OK:
    The generator pulley with clutch locks when turned clockwise and turns freely when turned counterclockwise.

    Result:
    Result
    Proceed to
    OK
    A
    NG (for DENSO Made)
    B
    NG (for BOSCH Made)
    C



B
REPLACE GENERATOR PULLEY WITH CLUTCH (Click here)

C
REPLACE GENERATOR PULLEY WITH CLUTCH (Click here)
A

REPAIR OR REPLACE GENERATOR ASSEMBLY


← ON-VEHICLE INSPECTION (from Jun 2011)Noise Occurs from V-ribbed Belt or Generator Assembly (from Aug 2013) →