REMOVAL
Removal / installation · Vehicles built Jun 2011 – Jul 2012
Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013
- HINT:
- Use the same procedure for RHD and LHD vehicles.
- The procedure listed below is for LHD vehicles.
| 1.
REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
|
 |
for Manual Air Conditioning System:
- Put protective tape around the center instrument cluster finish panel.
Text in Illustration
*1
|
Protective Tape
|
Using a moulding remover, detach the 10 claws and 4 clips.
- Detach the 4 claws and disconnect the air conditioner control.
Disconnect the connectors and remove the center instrument cluster finish panel.
for Automatic Air Conditioning System:
- Put protective tape around the center instrument cluster finish panel.
Text in Illustration
*1
|
Protective Tape
|
Using a moulding remover, detach the 8 claws and 4 clips.
Disconnect the connectors and remove the center instrument cluster finish panel.
| 2.
REMOVE LOWER HEATER CONTROL BASE |
 |
- Remove the 4 screws.
- Remove the 4 screws.
Detach the 3 claws and disconnect the lower heater control base.
| 3.
DISCONNECT NO. 1 COOLER WIRE |
 |
Disconnect the No. 1 cooler wire as shown in the illustration.
| 4.
REMOVE HEATER CONTROL BASE |
 |
- Detach the 4 claws and remove the heater control base.
| 5.
REMOVE AIR CONDITIONING AMPLIFIER ASSEMBLY |
 |
- Disconnect the No. 1 cooler wire from the air conditioning amplifier assembly as shown in the illustration.
Text in Illustration
*1
|
Air Conditioning Amplifier Assembly
|
*2
|
No. 1 Cooler Wire
|
Remove the air conditioning amplifier assembly.