2014 Hilux · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Jun 2011


CHECK DRIVE BELT TENSION

A074147E01
  1. Visually check the belt for cracks, oiliness or wear. Check that the belt does not touch the bottom of the pulley groove.
    If necessary, replace the belt.

  1. A121452E01
    Check the drive belt deflection by pressing on the belt at the points indicated in the illustration with 98N (10 kgf, 22 lbf) of pressure.

    Standard drive deflection:
    Item
    Specified Condition
    New belt
    7.5 to 9.5 mm
    (0.30 to 0.37 in.)
    Used belt
    9.0 to 13 mm
    (0.35 to 0.51 in.)

    1. If necessary, adjust the drive belt deflection.
      Reference:

  1. Using a belt tension gauge, check the drive belt tension.

    Standard drive belt tension:
    Item
    Specified Condition
    New belt
    441 to 539 N
    (45 to 55) kgf
    Used belt
    245 to 343 N
    (25 to 35) kgf

    1. If the belt tension is not as specified, adjust it.

  1. A121453E01
    Check the drive belt deflection by pressing on the belt at the points indicated in the illustration with 98N (10 kgf, 22 lbf) of pressure.

    Standard drive belt deflection:
    Item
    Specified Condition
    New belt
    11 to 15 mm
    (0.43 to 0.59 in.)
    Used belt
    15 to 20 mm
    (0.59 to 0.79 in.)

    1. If necessary, adjust the drive belt deflection.
      Reference:

  1. Using a belt tension gauge, check the drive belt tension.

    Standard drive belt tension:
    Item
    Specified Condition
    New belt
    372 to 608 N
    (38 to 62 kgf)
    Used belt
    196 to 392 N
    (20 to 40 kgf)

    1. If the belt tension is not as specified, adjust it.

  1. A121454E01
    Check the drive belt deflection by pressing on the belt at the points indicated in the illustration with 98N (10 kgf, 22 lbf) of pressure.

    Standard drive belt deflection:
    Item
    Specified Condition
    New belt
    7.0 to 10 mm
    (0.28 to 0.39 in.)
    Used belt
    10 to 14 mm
    (0.39 to 0.55 in.)

    1. If necessary, adjust the drive belt deflection.
      Reference:

  1. Using a belt tension gauge, check the drive belt tension.

    Standard drive belt tension:
    Item
    Specified Condition
    New belt
    441 to 539 N
    (45 to 55 kgf)
    Used belt
    196 to 343 N
    (20 to 35 kgf)

    1. If the belt tension is not as specified, adjust it.

      NOTICE:
      1. Check the drive belt deflection at the specified point.
      2. When installing a new belt, set its deflection value as specified.
      3. When checking a belt used for over 5 minutes, confirm the deflection value is within the specified range.
      4. When reinstalling a belt used for over 5 minutes, perform the check based on the used deflection value.
      5. V belt tension and deflection value should be checked after 2 revolutions of engine cranking.
      6. When using a belt tension gauge, confirm the accuracy first by using a master gauge.

← COMPONENTS (from Jun 2011)REMOVAL (from Jun 2011) →