2014 Hilux · Service Manual BRAKE

C1248/48 Open Circuit in Rear Differential Lock

Diagnostic trouble codes · Vehicles built from Jun 2011

DESCRIPTION

DTC No.
DTC Detection Condition
Trouble Area
C1248/48
With vehicle speed is 50 km/h (30 mph) or more, rear differential lock switch changes from OFF to ON 3 seconds or more have passed
  1. Transfer indicator switch (rear differential lock)
  2. Skid control ECU
  3. Wire harness

WIRING DIAGRAM

F100584E01

INSPECTION PROCEDURE


1. INSPECT TRANSFER INDICATOR SWITCH (REAR DIFFERENTIAL LOCK)

  1. F052057E03
    Measure the resistance of the switch.

Standard resistance:
Tester Connection
Switch Condition
Specified Condition
1 - 2
Pushed
Below 1 Ω
1 - 2
Not pushed
10 kΩ or higher



NG
REPLACE TRANSFER INDICATOR SWITCH (REAR DIFFERENTIAL LOCK)
OK


2. CHECK WIRE HARNESS (TRANSFER INDICATOR SWITCH - SKID CONTROL ECU AND BODY GROUND)

  1. C123166E09
    Disconnect the S2 ECU connector.

  1. Disconnect the T31 switch connector.

  1. Measure the resistance of the wire harness side connectors.

Standard resistance:
Tester Connection
Tester Connection
T31-2 - S22-22 (EXI2)
Below 1 Ω
T31-2 -Body ground
10 kΩ or higher
T31-1 -Body ground
Below 1 Ω



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE BRAKE ACTUATOR ASSEMBLY


← C1243/43 Acceleration Sensor Stuck Malfunction (+ C1244/44, C1245/45, C1279/79) (from Jun 2011)C1249/49 Open in Stop Light Switch Circuit (from Jun 2011) →