2014 Hilux · Service Manual ENGINE

REPLACEMENT

Removal / installation · Vehicles built from Jun 2011


1. REPLACE CONNECTING ROD SMALL END BUSH

  1. A057244E02
    Using SST and a press, press out the bushing.
    SST
    09222-54011   (09222-03016, 09222-03026)

  1. A056739E01
    Using a round file, lightly file off any roughness from the small end of the connecting rod.

  1. A057240E02
    Attach a new bush to SST with the ball of SST inside the oil hole of the bush.
    SST
    09222-54011   (09222-03021)

  1. A056722E02
    Align the oil holes of the bush and connecting rod.

  1. A057245E02
    Using SST and a press, press in the bush.
    SST
    09222-54011   (09222-03016, 09222-03026, 09222-03021)

  1. A057241E01
    Using a pin hole grinder, hone the bush to obtain the standard clearance between the bush and piston pin.

  1. Check the piston pin fit at normal room temperature.

    1. A057242E01
      Coat the piston pin with engine oil, and push it into the connecting rod with your thumb.


2. REPLACE OIL PUMP SEAL

  1. A057638E01
    Using a screwdriver, pry out the oil seal.

  1. A057640E02
    Using SST and a hammer, tap in a new oil seal until its surface is flush with the timing belt case edge.
    SST
    09214-60010  

  1. Apply MP grease to the lip of the oil seal.


3. REPLACE ENGINE REAR OIL SEAL

  1. A057266E01
    Using a screwdriver and hammer, tap out the oil seal.

  1. A057639E02
    Using SST and a hammer, tap in a new oil seal until its surface is flush with the rear oil seal retainer edge.
    SST
    09223-15030  
    09950-70010   (09951-07100)

  1. Apply MP grease to the lip of the oil seal lip.

← INSPECTION (from Jun 2011)REASSEMBLY (from Jun 2011) →