2014 Hilux · Service Manual ENGINE

REPAIR

Removal / installation · Vehicles built from Jun 2011


1. REPAIR INTAKE VALVE SEAT

  1. A057247E02
    Check the valve seating position.

    1. Apply a light coat of prussian blue (or white lead) to the valve face.

    2. Lightly press the valve against the seat. Do not rotate valve.

  1. Check the valve face and seat for the following:

    1. If blue appears 360° around the face, the valve is concentric. If not, replace the valve.

    2. If blue appears 360° around the valve seat, the guide and face are concentric. If not, resurface the seat.

    3. Check that the seat contact is in the middle of the valve face with the width below.

      Standard width:
      1.5 to 1.9 mm (0.059 to 0.075 in.)

  1. A053831E11
    If the seating is too high on the valve face, use 30 and 45° cutters to correct the seat.

  1. A053832E11
    If the seating is too low on the valve face, use 60 and 45° cutters to correct the seat.

  1. A057258E01
    Hand-lab the valve and valve seat with an abrasive compound.

  1. After hand-lapping, clean the valve and valve seat.


2. REPAIR EXHAUST VALVE SEAT

  1. A057246E02
    Check the valve seating position.

    1. Apply a light coat of prussian blue (or white lead) to the valve face.

    2. Lightly press the valve against the seat. Do not rotate valve.

  1. Check the valve face and seat for the following:

    1. If blue appears 360° around the face, the valve is concentric. If not, replace the valve.

    2. If blue appears 360° around the valve seat, the guide and face are concentric. If not, resurface the seat.

    3. Check that the seat contact is in the middle of the valve face with the width below.

      Standard width:
      1.8 to 2.2 mm (0.071 to 0.087 in.)

  1. A053831E11
    If the seating is too high on the valve face, use 30 and 45° cutters to correct the seat.

  1. A053832E11
    If the seating is too low on the valve face, use 60 and 45° cutters to correct the seat.

  1. A057257E01
    Hand-lap the valve and valve seat with an abrasive compound.

  1. After hand-lapping, clean the valve and valve seat.

← INSTALLATION (from Aug 2013)COMPONENTS (from Jun 2011) →